Force 8 F8-112 Twin A1P2 Replacement Filters

This pair of F8-112 filters are of filter type A1P2 and come in a hang bag for clean storage. These are replacement filters to fit the Force 8 Half-Mask with...
£15.29 £16.99

This pair of F8-112 filters are of filter type A1P2 and come in a hang bag for clean storage. These are replacement filters to fit the Force 8 Half-Mask with Typhoon Valve and A1P2 filters.

Replace the filters periodically. If you start to smell the odour of the paint or it becomes difficult to draw air through the filter, then it is time to replace your cartridges. Preferably replace them periodically before this occurs to ensure you are fully protected.

PLEASE NOTE:
When installing the filters to your mask, please note that the filters do require a reasonable amount of force to be applied to rotate them into the “locked” position. This is to ensure that the gasket between the filters and the mask body is well compressed and therefore sealing the interface efficiently. When carrying out this operation, just take care not to grip the exhaust valve body inside the mask. However, you may hold the overall mask body with the required force to rotate the filters into the “locked” position. Do not twist both filters at the same time.

Click below for a short video on how to fit the filters correctly.

GUIDE TO FITTING FILTERS

A1P2 cartridges are suitable for protecting your respiratory system from:

  • Solvent-based painting
  • Water-based painting
  • Rubbing down paint
  • Paint stripping
  • White spirit
  • Welding (ferrous and lead)
  • Organic vapours and gases
  • Dusts
  • Mists
  • Fibres and fibre glass
  • Plaster
  • Wood (hard and soft)
  • Nuisance odours

Conformity:
The filters confirm to EN140 (Face piece), EN14387:2004 (Filter performance), EN143:200 (Filter performance).


Best Sellers